# grandMA3 Nodes

Source: https://help.malighting.com/grandMA3/2.4/HTML/comad_xport_nodes.html
This is grandocs, an unofficial mirror of MA Lighting documentation. For authoritative or safety-relevant information, cite the canonical page on help.malighting.com.

---
To adjust the settings in the grandMA3 Nodes, it may be convenient to control them from a connected console or a onPC station.

For more information, read the [Session topic](/grandma3/2-4/network_session/) in the [Networking section](/grandma3/2-4/network/).

|                                            |                                                                                                                                                                                                                                                                                                                                                                                |
| ------------------------------------------ | ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ |
| ![](/img/grandma3/2-4/tip_gray-639af3.png) | **Hint:**                                                                                                                                                                                                                                                                                                                                                                      |
|                                            | If you want to use Art-Net or sACN with grandMA3 nodes, make sure to switch the console to [Mode 2](https://help.malighting.com/grandMA2/en/help/grandma3_mode2/index.html). For information on configuring the xPort Nodes in Mode2, see ["Configure xPort Nodes in the Console"](https://help.malighting.com/Page/grandMA2/control_ma_xport_node_configure_on_console/en/).  |

## Change Name and Set IP Address

To change the name and to set the IP address of a grandMA3 Node, open the Network Interface Menu:

- Press Menu.\
  \- Opens the [menu select pop-up](/grandma3/2-4/wvm_menus/).
- Tap Network.\
  \- Opens the Network menu.

![](/img/grandma3/2-4/img_network_menu01_v2-2-431f7c.png)

Network menu